Leto Ultra II
- Inputs: 6
- New: 3 Balanced and 3 Single ended
- New: Extra balanced input replaces the cinema bypass
- New: Maximum peak input level 7 volts RMS
- New: Maximum peak output level of 13 Volts RMS
- New: Presence control, 6 position
- Gain
- New: 3 Gain positions, 9dB, 6dB, 3dB
- New: Remote control 3 position gain
- New: Manual gain switch on rear panel
- New: Gain setting saved for each input
- Detailed Specs
- New: Upgraded circuits throughout
- New: Tubes: 2ea. 12DW7 inputs, 2ea. 12AU7 outputs
- New: Remote control: Volume, Inputs, Presence,
- Gain, Mute and Mono
- New: All controls operate remotely or manually
- New: 9 button remote
- New: Distortion ~ 0.03% at 1V RMS input
- New: Frequency response 10Hz to 40Khz ~ 2dB
- New: Weight: 28
- New: Power consumption 30 W
- ESP Supplues: Using toroid transformers 300 Volt and 12 Volt
- What’s the same
- Output Grd switches
- 100% analog tube circuitry throughout the signal path
- Gold pin sockets
- Dimensions
- Recessed gold pin connectors
- 16 gauge steel
- Outputs 2 Balanced and 2 Single ended (150 Ohms)
- Signal to noise ~ 100dB below operating level
- Non-inverting output polarity
- Cross talk >90dB
- Polypropylene capacitors throughout the audio path
Leto 1.5 is replaced by Leto Ultra II
- Inputs: 5
- 2 Balanced and 3 Single ended
- SE cinema bypass
- Maximum peak input level 5 volts RMS
- Maximum peak output level of 8 Volts RMS
- Headphone amp or Balance control
- Gain
- 2 Gain positions, 12dB and 3dB
- Internal Gain set at factory
- Detailed Specs
- Tubes: 2ea. 12AX7 inputs, 2ea. 12AU7 outputs
- Remote control: Volume, Mute and Mono
- Remote bypass switch
- 4 button remote
- Distortion ~ 0.02% at 1V RMS input
- Frequency response 10Hz to 40Khz ~ 1dB
- Weight: 25
- Unity gain set for 12dB
- Power consumption 27 W
- 2 Linear power supplies, 250V and 12V
- What’s the same
- Output Grd switches
- 100% analog tube circuitry throughout the signal path
- Gold pin sockets
- Dimensions
- Recessed gold pin connectors
- 16 gauge steel
- Outputs 2 Balanced and 2 Single ended (150 Ohms)
- Signal to noise ~ 100dB below operating level
- Non-inverting output polarity
- Cross talk >90dB
- Polypropylene capacitors throughout the audio path